MOSFET

Used to convert the Dynon PWM dimming Ground signal into a PWM dimming power signal to drive all dimmed LEDs.

The MOSFET is an IRF4905, with a 10k resistor connected across Gate and Source.  The Pinouts above are Gate=124, Drain=208, Source=209.

​

The Gate is connected to the Skyview D37 Pin 26 (White wire), the Drain is connected to Distribution block FL5 to provide dimmed power, and the Source is connected to Distribution block EL5 to supply the MOSFET with power.

​

The MOSFET is located behind the panel, just fore of the Comm module, and is accessible through the front door.

Chuck Deerinck © 2013 all rights reserved.